Your Selected Vehicle
Parts for your 1986 Suzuki Jimny-Batteries
Narva Model 72 Rear Stop/Tail/Indicator Lamp With In-Built Retro Reflector, With 0.5M Of Cable
Explore 4WD & Adventure
Narva 9-33 Volt LED Rear Stop/Tail, Right Hand Squential direcion indicator and reverse lamps with in built retro reflector and 0.5m hard wired cable - 97312R
Narva Model 72 Rear Stop/Tail/Indicator/Reverse Lamp With In-Built Retro Reflector, With 0.5M Of Cable
Narva Model 70 Rear Stop/Tail/Indicator Lamp With In-Built Retro Reflector, With 0.5M Of Cable
Narva MDL34 Stop/Tail/Indicator Light With Licence Plate Lamp LED 12V - 2 Pce - 93440BL2
Narva Model 70 Rear Stop/Tail/Indicator/Reverse Lamp With In-Built Retro Reflector, With 0.5M Of Cable
Narva 9-33 Volt Surface Mount LED front end outline marker(white) with Chrome cover and 0.5m cable and Deutsch connector - 96812-D
Narva Model 70 Rear Stop/Tail /Indicator Lamp With In-Built Retro Reflector, With 0.5M Of Cable, Bulk Pack Of 4 - 97000-1/4
1986 Suzuki Jimny batteries: purpose, upkeep, and when to replace
Yes, a battery is absolutely fitted to the 1986 Suzuki Jimny (sold in Australia and New Zealand as the Sierra in many trims). Technical sources such as the Suzuki SJ413/Sierra Factory Service Manual (1984–1988), the Suzuki Genuine Parts Catalogue for MY1986, and the Haynes manual for Suzuki SJ410 & SJ413 (1982–1990) specify a 12‑volt negative‑earth lead‑acid starting battery working with an alternator‑regulated charging system. Those references outline battery inspection, charging voltages, and removal/refit procedures—clear proof the vehicle relies on a conventional 12 V battery.
On this classic, the battery’s job is straightforward: it cranks the starter, feeds the ignition system and coil, and powers lights, instruments, wipers, radio, and accessories under the bonnet and in the cab. Off-road extras like driving lights or a small winch can also call on it, with the alternator topping things up while the engine runs.
As part of regular servicing, it’s smart to give the Jimny’s battery a once-over. Most examples run a flooded lead‑acid unit, so if it’s a serviceable design, check electrolyte levels and top up with distilled water as needed. Keep the terminals clean and snug, and make sure the hold‑down clamp is tight enough to resist corrugations and track work without crushing the case. With the engine idling, a healthy charging system should show roughly 13.8–14.5 V at the posts