PowerTrain Jumper Leads 900A Surge Protected 3.5m - BC900SP

PowerTrain Jumper Leads 900A Surge Protected 3.5m

PowerTrain have made these quality surge protected jumper leads to suit large cars, 4wds and commercial vehicles.

Make sure you follow the instructions on the pack before connecting your jumper leads. Make sure the batteries are of the same voltage, make sure the car's don't touch, make sure the engines are off, the car is in neutral or park and the handbrake is on before connecting the battery jumper cables.

Vehicle starting sequence for negatively earthed vehicles:

1. Connect the RED lead to the positive + terminal of both vehicles batteries.
2. Then connect the BLACK lead to the negative - terminal of the boosting battery and then the engine block of the vehicle with the FLAT battery.
3. Start the engine of the BOOSTING vehicle and allow engine to idle normally.
4. Start the engine of the vehicle with the FLAT battery and allow engine to idle normally.
5. Once the engine of the vehicle with the FLAT battery is idling normally, turn off the BOOSTING vehicle and disconnect the booster cables in the reverse order.

Repco's range of Jumper Leads are ready jump start a car whenever you need to. Check out the full range of Battery chargers, jump starters online or visit a Repco store near you.